However much you try to keep your mountain bike in admirable condition, wear and tear plus age predictably catch up. Regular maintenance and buying of replacement parts can mount up, requiring you to dig deeper into your pockets. However, with the right tools and a little skill, you can cut down on some of the expenses while understanding better how your bike works. Here are some of the maintenance tasks you MUST know as a mountain bike owner.

1. Fixing Fresh Handlebar Tape

Using fresh tape is one of the best ways to pep up the way your bike feels and looks. The procedure looks simple, but you might end up wasting a lot of tape, which can end up being costly if you splurged on high-end tape.

The procedure is simple, you first have to secure the gear and brake cables to make sure they don’t cross. Start the taping by an inch or two in the bar before you start wrapping the tape around it. Make the wraps uniform, choosing to wrap the tape outwards or inwards. Keep the overlap width consistent, a recommended width is half the width of the tape. Use a couple of wraps preferably by electrical tape or finishing tape to complete the process before replacing the bar end plug.

2. Proper Lubrication

Lack of lubrication represents one of the top causes of mountain bike problems. This lack can cause your bearings to grind, leading to metal on metal rubs, which eventually affects the way your bike runs.

You need to check for lubrication once every month, and perform the necessary steps to correct the issue. You need to apply the right amount of lubricant because if you apply excess you end up with a dust and dirt magnet. If you apply too little, you risk damage to vital bike parts.

Use extra-dry Teflon lubricant on general-purpose mountain bikes. This is because the lubricant will stay dry on the chain, minimizing dust attraction. Put a few drops of the lube on the chain links while running the gears up and down. You also need to lubricate your cables as well, especially brake cables. Put a few drops at the point where the cable enters the housing to prevent cable corrosion. Wipe off any excess lubricant after completing the process.

3. Brake Adjustment

Before getting on the road, you MUST check the state of your breaks. These brakes form the line between reaching your destination safely and ending up in the hospital. First, check the pads for lines or exposed metal. Listen for a grinding sound that indicates that your pads are hitting too low or too high, and sand the pads down. Next, check the brake cables for wear and breakages. Replace the cable if you notice any anomalies.

DIY Won’t Work all The Time…

If everything fails, you might have to turn to an expert repairperson to handle the issue. But you need to know that regular repair weakens your bike. You also end up spending more on repair, money that you can channel to a new bike. You can get an idea of what you want at http://www.cyclingplaza.com/mountain-bike-reviews/, and make a perfect choice for a replacement.